3/8" X 3" Stainless Steel Flat Sleeve Anchor, 50/Box

CONFAST - 3/8" X 3" Stainless Steel Flat Sleeve Anchor

These anchors come packaged with 50 pcs per box and are designed for fastening items to concrete.

• Bit size
• Do not use in vibratory loads
• 3/8" inch diameter x 3" inch long
• Spacing must be a minimum of 10 anchor diameters
• Free freight on all orders over $25.00

Applications
The anchor is made from . This anchor is designed for use in

Head Style
The anchor is a Flat Head head

Diameter of Anchor
The diameter of the anchor is 3/8".

Length Anchor
The length of the anchor is 3"

Depth of Hole
The depth of the hole that is required for the anchor should be a minimum of 1/2" deeper than the anchor will penetrate the concrete. This will allow space for dust created during the installation process to fall, which will prevent the anchor from bottoming out in the hole before full penetration into the concrete.

1. Drill a hole into the concrete using a carbide-tipped bit that meets ANSI Standards B212.15.
2. Drill the hole a 1/2" deeper than the anchor will penetrate the concrete, making sure the minimum embedment requirements of is met.
3. Clean the hole with a wire brush, vacuum, compressed air, or a blow-out bulb.
4. Insert the point of the 3/8" X 3" Stainless Steel Flat Sleeve Anchor into the hole. Make sure that the screw being installed will penetrate the base material a minimum of 1" but no deeper than 1-3/4".
5. Turn the screw clockwise, applying slight pressure until the head of the screw is snug against the material being fastened.
6. Always use proper personal protective equipment per manufacturer's and OSHA instructions.